My Favorite Police Officer Calls Me Mom shirt
We have a machine at work that I operate that basically gets components from a My Favorite Police Officer Calls Me Mom shirt and places it onto the PCB. I apply the solder paste through the use of a stencil beforehand.I wish I did more component level repairs at work to justify having this. As it is, it a while to get the boss to pay for something better than a Weller hobby iron with the worst warm up time I’ve ever seen. It was like trying to solder with an Easy Bake Oven light as the heat source.I create solder stencils for just this type of work, makes multi component boards much easier to work. Line up stencil, slap on paste and Place components or send it to the pick and place machine.
Best My Favorite Police Officer Calls Me Mom shirt
I’m thinking of all the time I’ve wasted on YouTube watching My Favorite Police Officer Calls Me Mom shirt videos, just waiting for something that actually amazed me. I open Reddit and I’m amazed in mere seconds. This is magical! I almost never solder anything but, I must have this in my life.I used to run Fuji robots for Motorola. These “Chip Shooters” or, “Pick & Place” machines used vacuum nozzles on a cam to suck up resistors, capacitors, IC chips on the back end, and drop them on a board covered in solder paste, which was screen printed onto them… They then enter a 30 ft long convection oven to gradually raise the temp to melt point, then cools it down… Where hand assembly took over…If the screen print was off and the components didn’t have sticky paste to grab them as they dropped, it could create quite a mess in a short time.That heat gun/paste approach looks a lot more efficient than spools of solder, flux and hot irons.